EKOCYCLE Cube User Manual page 34

NOTE: The print jets will begin to heat .
CAUTION: Do not touch the print jets until they have cooled to
room temperature .
NOTE: The estimated time to completion is noted at the bottom
of the screen .
NOTE: The blue bar is a progress indicator that shows the status
of the print jet heating process .
NOTE: The blue bar is a progress indicator that illustrates the
status of the print .
NOTE: Select PAUSE
CANCEL if you wish to cancel the print job .
NOTE: Press the time at the bottom of the screen to view the
percentage of completion . Press it again to view how many
layers have been printed . After a few seconds, the default time
will appear again .
NOTE: If you selected
CANCEL again to confirm your decision . Otherwise, select
RESUME to continue printing .
5 . Once the printer has finished printing, select the
NOTE: Once the print has completed, the print jets will begin
to cool .
CAUTION: Do not touch the print jets until they have cooled
to room temperature .
6 . Refer to the section titled
removing your creation from the print pad .
3D Systems, Inc.
to temporarily stop printing . Select
CANCEL to cancel the print, select
checkmark
Finishing Your Creation
to continue .
for information about
30