Table of Contents
Advertisement
PRINTER CALIBRATION
Printer Calibration is originally performed by the manufacturer . When Level Gap, Auto Gap and Manual Gap have been
successful but the bottom layer of your print appears stringy and not tightly fused together, your printer should be
calibrated .
NOTE: Auto Level should always be performed before the Auto Gap procedure .
1 .
Navigate to the Printer Calibration screen and select CALIBRATE .
2 .
Select
Auto
Cal .
NOTE: The printer will maneuver the print pad to center it and
then position it under the print jet nozzles .
3 .
Lower the value on your display by 1 .00 using the down arrow .
NOTE: The value displayed may be different from the
illustration . Referring to this illustration, your target value
would be close to -4 .76 . If the value displayed is 6 .23, your
target value would be close to 5 .23 . The final adjustment value
should be close to the target value but does not need to be
exact .
4 .
Insert the gap gauge between the print pad (A) and the left print jet
nozzle (B) .
NOTE: The left print jet is print jet 1 .
3D Systems, Inc.
B
88
A
Hide quick links:
Advertisement
Table of Contents
