Manual Gap Adjustment - EKOCYCLE Cube User Manual

Manual Gap Adjustment

If Auto Gap is not successful, you may perform a manual gap adjustment to ensure the first layer of the part prints
properly .
NOTE: The print pad must be clean and free from glue and print material .
NOTE: Ensure the print jet nozzles are clean and free from print material . This can usually be accomplished
by pulling out the print material with your fingers .
Caution: Ensure the print jet nozzles are at room temperature before attempting to clean them .
1 . Select MANUAL GAP
2 . Place the gap gauge on top of the print pad under the left print jet .
checkmark
Select the
NOTE: Ensure the left cartridge is installed before performing
this procedure .
NOTE: The Gap Gauge is a thin polyester strip approximately
8 .5" (216 mm) long and 1 .5" (38 mm) wide .
3 . Gently slide the gap gauge back and forth between the print pad and
the left print jet . Using the arrows, raise or lower the print pad until you
feel a slight resistance on the gauge . Select the
feel the proper resistance .
Caution: Exercise caution to prevent the print jet from pressing
into the print pad . Once you feel a slight resistance in the Gap
Gauge as it moves between the print pad and the left print jet,
the gap is correct .
3D Systems, Inc.
ADJUSTMENT .
to continue .
checkmark when you
86