EKOCYCLE Cube User Manual page 96

18 . When prompted, tighten the lock screw enough to ensure the
adjustment knob does not easily turn . Select the
continue .
Caution: Do not over-tighten the lock screw . This can damage
the adjustment knob and void the manufacturer's warranty .
19 . Reinstall the print pad and select the
Level procedure again .
NOTE: Select SKIP
recommended that Auto Level procedure is performed again .
20 . Once Auto Level is successful, the printer will being checking the Z-gap .
NOTE: The printer will perform an automated gap measurement .
This may take a few minutes .
21 . Select the checkmark
3D Systems, Inc.
checkmark
to bypass the Auto Level procedure . It is
to continue .
checkmark
to
to perform the Auto
92