EKOCYCLE Cube User Manual page 106

Hide thumbs Also See for Cube:
Table of Contents

Advertisement

NOTE: The printer will check for a firmware update .
NOTE: The printer will begin to transfer new firmware . The blue
bar is a progress indicator .
NOTE: The transfer could take a few minutes .
WARNING: DO NOT POWER OFF OR DISCONNECT THE PRINTER
FROM UTILITY POWER DURING THE UPDATE PROCESS .
NOTE: If no new firmware is available, select the
checkmark
to
continue .
NOTE: If the firmware transfer fails, select
RETRY
to start the
transfer again . Select
CANCEL
if you do not want to update the
firmware .
NOTE: The firmware will begin to install . The blue bar is a
progress indicator .
NOTE: The installation could take a few minutes .
WARNING: DO NOT POWER OFF OR DISCONNECT THE PRINTER
FROM UTILITY POWER DURING THE UPDATE PROCESS .
3D Systems, Inc.
102

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents