Replacing The Jet Wipers; Procedure - EKOCYCLE Cube User Manual

REPLACING THE JET WIPERS

After a predetermined number of print jet cycles over the jet wipers the display will prompt you to replace it before
printing another creation .
NOTE: When the left jet wiper has reached the end of its
useful life, the printer will prompt you to replace it . Select the
checkmark to continue .
NOTE: When the right jet wiper has reached the end of its
useful life, the printer will prompt you to replace it . Select the
checkmark to continue .
NOTE: If you have replaced the jet wiper, select the
to reset the printer count . Press

Procedure

1 . Remove the purge bin assemblies from the printer .
3D Systems, Inc.
checkmark
SKIP to be reminded later .
80