EKOCYCLE Cube User Manual page 88

8 . Reinstall the print pad and select the
Level procedure again .
NOTE: Select SKIP
Level should be performed again .
9 . Once Auto Level is successful, the printer will begin checking the Z-gap .
NOTE: The printer will perform an automated gap measurement .
This may take a few minutes .
10 . Select the checkmark
NOTE: If Auto Gap is not successful, it is recommended that
you perform Auto Level and Auto Gap again . Select
LEVEL to continue .
NOTE: If Auto Gap is not successful the second time, select
PLATE MAINTENANCE . For more information, refer to
the section titled Print Pad Maintenance . Once the PLATE
MAINTENANCE procedure has been performed, perform Auto
Level and Auto Gap .
NOTE: If Auto Gap is still not successful, select
GAP ADJUSTMENT . Refer to the section titled Manual Gap
Adjustment for more information . Once the Manual Gap
Adjustment procedure has been performed, note the final
reading for future reference .
3D Systems, Inc.
checkmark
to bypass the Auto Level procedure . Auto
to continue .
to perform the Auto
AUTO
MANUAL
84