EKOCYCLE Cube User Manual page 24

NOTE: When prompted, tighten the lock screw enough to
ensure the adjustment knob does not easily turn . Select the
checkmark to perform Auto Level again .
Caution: Do not over-tighten the lock screw . This can damage
the adjustment knob and void the manufacturer's warranty .
checkmark
22 . Select the
23 . Install the print pad and select the
NOTE: To install the print pad, place it on top of the adjustment
knobs . When the print pad is centered properly, magnets will
secure the print pad to the adjustment knobs .
NOTE: The printer will perform an automated gap measurement .
checkmark
24 . Select the
NOTE: The value presented on the touchscreen display is the
absolute print pad position . Note and refer to this value when
performing the Manual Level procedure . Your number may differ
from the illustration .
3D Systems, Inc.
to continue .
checkmark to perform Auto Gap .
to continue .
20