Operation Procedures; Applying Cube Glue - EKOCYCLE Cube User Manual

10

OPERATION PROCEDURES

APPLYING CUBE GLUE

Cube Glue contains water-soluble glue that adheres the part to the print pad . It is important that glue is applied to the
print pad before starting any print to ensure that the creation does not move during the printing process .
Cube Glue contains a foam applicator under the cap . It is recommended that the bottle is turned upside-down with the
cap on to allow the glue to settle into the applicator before applying .
For best results, apply two thin layers of Cube Glue to the print pad using slow circular motions when prompted by
the touchscreen display . Apply the glue in an overlapping pattern . The coverage dimensions should be larger than the
footprint of the creation you are printing to ensure proper adhesion .
Layer 1
Apply a thin layer of Cube Glue to the print pad following the illustration below:
Layer 2
Apply a second thin layer of Cube Glue to the print pad following the illustration below:
NOTE: For best results, allow the glue to dry before printing .
3D Systems, Inc. 72