Table of Contents
Advertisement
14 . Once the Auto Level procedure has completed, select the
continue . If Auto Level is successful, proceed to step 20 .
NOTE: If the print pad is out of range, you will need to perform a
manual adjustment .
15 . Remove the print pad and select the
NOTE: To remove it, lift up the front of the print pad and pull it
out of the printer . The print pad is magnetically attached to the
adjustment knobs .
16 . When prompted, loosen the lock screw that is indicated on the
touchscreen display . Select the
NOTE: Use a 1 .5 mm Allen wrench that is included with the
printer .
NOTE: The lock screw (1) is located just below the adjustment
knob (2) . The lock screw for adjustment knob B can be accessed
from the front of the printer . The lock screw for adjustment knob
A can be accessed from behind the printer .
17 . Follow the instructions on the touchscreen display . Once the
adjustments have been made, select the
3D Systems, Inc.
checkmark
to continue .
checkmark
to continue .
checkmark
to continue .
91
checkmark
to
1
2
Hide quick links:
Advertisement
Table of Contents
