Warranty; Limitation Of Liability - EKOCYCLE Cube User Manual

CAN ICES-3 (B)/NMB-3(B)
This device complies with Industry Canada license-exempt RSS standard(s) . Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device .
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence .
L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement .

WARRANTY

3D Systems warrants that the EKOCYCLE Cube 3D Printer will be free from defects in materials and workmanship,
during the applicable warranty period, when used under the normal conditions described in the documentation provided
to you, including this user guide . 3D Systems will promptly repair or replace the EKOCYCLE Cube 3D Printer, if required,
to make it free of defects during the warranty period . This warranty excludes (i) normal consumable or expendable
parts (such as Material Cartridges, Print Pads, and Cube Glue), (ii) repairs required during the warranty period because
of abnormal use or conditions (such as riots, floods, misuse, neglect or improper service by anyone except 3D Systems
or its authorized service provider), and (iii) repairs required during the warranty period because of the use of non-
integrated, non-approved or non-licensed materials in the EKOCYCLE Cube 3D Printer . The warranty period for the
EKOCYCLE Cube 3D Printer is ninety (90) days and shall start on the date your EKOCYCLE Cube 3D printer is activated .
For consumers who are covered by consumer protection laws or regulations in their country of residence, the benefits
conferred by our ninety (90) day warranty are in addition to, and operate concurrently with, all rights and remedies
conveyed by such consumers protection laws and regulations, including but not limited to these additional rights .
THIS WARRANTY IS THE ONLY WARRANTY PROVIDED FOR THE EKOCYCLE CUBE 3D PRINTER . TO THE MAXIMUM
EXTENT PERMITTED BY LAW, 3D SYSTEMS EXPRESSLY DISCLAIMS ALL OTHER WARRANTIES FOR THE EKOCYCLE
CUBE 3D PRINTER AND EACH OF ITS COMPONENTS, WHETHER THOSE WARRANTIES ARE EXPRESS, IMPLIED OR
STATUTORY INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR INTENDED OR PARTICULAR
PURPOSES .

LIMITATION OF LIABILITY

3D SYSTEMS WILL NOT BE RESPONSIBLE FOR CONSEQUENTIAL, EXEMPLARY OR INCIDENTAL DAMAGES (SUCH
AS LOSS OF PROFIT OR EMPLOYEE'S TIME) REGARDLESS OF THE REASON . IN NO EVENT SHALL THE LIABILITY
AND/OR OBLIGATIONS OF 3D SYSTEMS ARISING OUT OF THE PURCHASE, LEASE, LICENSE AND/OR USE OF THE
EQUIPMENT BY YOU OR OTHERS EXCEED THE PURCHASE PRICE OF THE EKOCYCLE CUBE 3D PRINTER .
Warranty Hotline from the Americas
888-598-1440 inside the US and
+1 678-338-3480 outside the US
weekdays during normal business
hours or by email at cubifysupport@
cubify .com .
3D Systems, Inc.
Warranty Hotline from Europe
+44 1442 279 839 (UK) or
+49 6151 357 499 (DE) weekdays
during normal business hours or by
email at cubifysupport@cubify .com .
2
Warranty Hotline from Europe
+44 1442 279 839 (UK) or
+49 6151 357 499 (DE) weekdays
during normal business hours or
by email at cubifysupport@cubify .
com .