Table of Contents
Advertisement
STORAGE
Putting into operation after storage
18.2
–
Cover the motorcycle with a porous sheet or blanket.
Info
Do not use non-porous materials since they prevent humidity from escaping,
thus causing corrosion.
Avoid running the engine for a short time only. Since the engine cannot warm
up properly, the water vapor produced during combustion condenses and causes
valves and exhaust system to rust.
–
Take the motorcycle off of the front wheel stand. (
–
Remove the rear of the motorcycle from the lifting gear. (
–
Recharge the battery.
–
Install the battery.
–
Set the clock with SET CLOCK. (
–
Fill up with fuel. (
–
Perform checks and maintenance measures when preparing for use. (
–
Take a test ride.
401059-01
x
(
p. 201)
x
(
p. 200)
p. 93)
p. 122)
p. 163)
p. 164)
p. 114)
238
Advertisement
Table of Contents
