Synchronizing The Time Code With An External Time Code Generator - JVC GY-HC900CHE Instructions Manual

Setting User's Bit without Opening the
Menu
.
Memo :
Settings cannot be made in the following cases.
0
When the [TC GEN] switch is set to
0
"REGEN".
Menu screen is displayed.
0
The camera recorder is not in the Camera
0
mode.
Setting the user's bit
1 Set the [TC DISPLAY] switch to "UB".
2 Set the [TC GEN] switch to a setting other
than "REGEN".
3 Press the [TC PRESET] button.
4 Set the user's bit (numbers between 0 and
9, or alphabets between A and F).
Use the cross-shaped button (HI) to place the
cursor at the item to set, then use the cross-
shaped button (JK) to change the values.
Memo :
Press the [CANCEL/RESET] button to reset
0
each digit to "0". The cursor moves to the left.
5 Check the values and press the Set button
(R).
The user's bit is set and the screen returns to
0
the normal screen.
To cancel the setting, press the [TC
0
PRESET] button.
Caution :
When the camera recorder is switched to Media
0
mode during editing, editing will be canceled
and the screen will close.
When editing the user's bit, operations of the
0
buttons configured in [Camera Function] B
[User Switch Set] are disabled.
80
Setting the User's Bit
PRESET
GEN
F-RUN
R-RUN
REGEN
DISPLAY
TC
UB
Synchronizing the Time
Code with an External
Time Code Generator
This camera recorder comes with a [TC IN]
terminal.
Connect a time code signal generator to the [TC
IN] terminal to synchronize with the SMPTE/EBU
LTC time code.
Memo :
After synchronization (slave lock), the internal
0
time code generator continues to run even if
there is no input from the external time code
generator.
Connection
Setting up the external time code generator as
a master device
To [TC IN] Terminal
of Another Camera
External Synchronizing Signal
Sync Signal
Generator
External Synchronizing Signal
External Time
Code Generator
Master Device
.
Slave Device
TC OUT
GENLOCK TC IN
LTC Time Code