Synchronizing Time Code On Another Camera - JVC Connected Cam GY-HC550U Instructions Manual

Synchronizing Time Code
on Another Camera
This camera recorder is equipped with a time code
input/output terminal ([TC] terminal).
Connect another camera recorder to the [TC]
terminal and synchronize to the time code.
1 Connect the [TC] terminal of the master
device with the [TC] terminal of the slave
device.
Set the [TC IN/OUT] switch of the master device
to "OUT", and the [TC IN/OUT] switch of the
slave device to "IN".
Master Device
[OUT]
Slave Device (This Camera Recorder)
[IN]
.
Settings and Operation of the Camera
Recorder
1 Set to Camera mode.
(A P24 [Operation Modes] )
2 Set [TC/UB] B [TC Generator] as follows.
Slave device:
0
Select "Free Run(Ext)".
Master device:
0
Select "Free Run".
3 Set LCD monitor or viewfinder to Display
screen.
4 Set the master device and run the time
code.
When the built-in time code generator is
0
synchronized with the external time code
data input, the Z icon on Display screen lights
up.
When time code is not synchronized or time
0
code input is not available, the Z icon goes
out.
1 /64
ND AE ±
0
4030 20 10 0
1 / 60
F2.8
.
Memo :
The built-in time code generator will continue
0
operation even when the master device is
disconnected after synchronization.
User's bit will become data in the master device.
0

Synchronizing Time Code on Another Camera

00: 00: 00.00
5 . 6f t
12 :34 :56
B 5600 K
ISO 102400
81