Front Brakes; Pad Removal - Polaris 2007 SPORTSMAN X2 800 Service Manual

BRAKES
2. Place new sealing washers on each side of banjo fitting on
the brake line and torque banjo bolt to specification.
Torque to 15 ft.lbs. (21 Nm)
Banjo Bolt
Brake Line
Banjo Bolt Torque:
15 ft.lbs. (21 Nm)
3. Fill reservoir with DOT-approved brake fluid.
NOTE: To speed up the brake bleeding procedure,
the master cylinder can be purged of air before
brake line is attached. Fill with DOT-approved brake
fluid and pump lever slowly two to three times with
finger over the outlet end to purge master cylinder of
air.
4. Follow proper bleeding procedures. Check all connections
for leaks and repair if necessary.
9.10
Sealing Washer
= T

FRONT BRAKES

Pad Removal

1. Elevate and support the of the ATV.
CAUTION
Use care when supporting vehicle so that it does not
tip or fall. Severe injury may occur.
2. Remove the wheel.
3. Loosen pad adjuster screw 2-3 turns.
4. Remove caliper from mounting bracket.