Polaris 2007 SPORTSMAN X2 800 Service Manual page 95

22. Remove the bolt and nut from the balance shaft gear. Try
to remove the balance shaft gear. If the gear does not come
off manually, use the Flywheel Puller (PN 2871043) to
remove the balance shaft gear.
23. Inspect the crankshaft gear (Q) for broken or worn teeth. If
the crankshaft gear does not need to be replaced, it does not
need to be removed. If the crankshaft gear is damaged,
remove the crankshaft gear with the Flywheel Puller (PN
2871043).
24. Install the two puller bolts (R). Tighten the puller bolts up
so that the bolts are at equal length.
R
2871043
Q
25. Install the Flywheel Puller (PN 2871043) and remove the
crankshaft gear, if needed.
26. Rotate the water/oil pump gear (S), so that all four bolts are
visible though the gear. Remove the four bolts with a hex
wrench. Pull out the pump.
S
27. Inspect the oil pump rotors for wear. Mark the rotors with
a white pen to ensure upon reassembly that the correct sides
of the rotors are installed and mesh with the same edges as
previously installed.
NOTE: If replacing the old rotors, new replacement
rotors will fit into the old oil/water pump housing.
ENGINE
2871043
3.39
3