Setting A New Service Interval - Polaris 2007 SPORTSMAN X2 800 Service Manual

ELECTRICAL
297 Ohms in Low
628 Ohms in High
Screen 5 - Programmable Service Interval:
The purpose of the programmable service interval is to provide
the consumer and dealer with a convenient reminder for routine
maintenance. When the ATV leaves the factory, this feature is
set at 50 hours.
Once the service interval mode is set with the hours when
service is due, the hours of actual engine operation are
subtracted from the set hours until 0 is reached. When the
counter reaches 0, the wrench icon will flash quickly for 10
seconds each time the vehicle is started as a reminder that the
periodic maintenance is due.
Set at 50 hours from factory
10.6

Setting A New Service Interval

1. While in the service interval mode, press and hold the
mode/override button until the wrench icon flashes. When
it begins to flash, release the button.
2. The setting will increase by one hour each time the button
is pressed. Pressing and holding the button will allow the
numbers to escalate much faster.
3. When the desired time increment is displayed, release the
button and wait for the wrench to stop flashing. When the
wrench stops blinking, your service hours are set.
NOTE: If you scroll past the intended number, hold
the button down until the count turns over to 0. You
can then reset the number.
Turn Service Interval OFF:
1. If the service interval is enabled (functioning) on your
ATV and you wish to turn it off, toggle to the service
interval mode.
2. Press and hold the mode button for approximately 7
seconds until the word OFF appears in the Rider
Information Center. The service interval is now OFF. To
enable (turn on) the service interval mode, repeat the steps
above in "Setting Service Interval After Countdown".
Change Service Interval Time
If you would like to change the service interval time, (example:
change the interval from 50 hrs. to 55 hrs.). Follow the steps
below:
1. While in the service interval mode, press and hold the
mode button for approximately 7 seconds until the word
OFF appears in the Rider Information Center.
2. Wait 5 seconds and then press the mode button in until the
wrench icon flashes. Press the mode button again to set the
desired service increment. Release the button and wait for
the wrench icon to stop flashing. The new service interval
is now set.
.