Polaris 2007 SPORTSMAN X2 800 Service Manual page 73

14. Refer to PVT System Chapter 6 to remove outer clutch
cover, drive belt, drive clutch, driven clutch, and inner
cover (F).
15. When removing starter cables, note and mark ground cable
and positive (+) cable mounting angle and locations.
Remove cables.
16. Remove transmission linkage rod from gear selector and
secure out of the way.
17. Disconnect coolant temperature sensor wire located on the
cylinder.
18. Remove engine to chassis ground cable.
19. Remove all engine mount nuts and / or engine mount plates.
F
20. Remove the engine from the left side of the frame.
NOTE: Use caution when lifting the engine out of
frame.
engine is too heavy to be lifted manually.
21. For engine installation, reverse procedures.
Remove the frame brace (G) from the front left side of the
frame.
Use an engine lift or other means if the
ENGINE
G
3
3.17