Save & Exit Setup; Exit Without Saving; Desktop Management Interface (Dmi) - DFI G586IPV User Manual

Save & Exit Setup
When all the changes have been made, highlight " Save & Exit Setup"
and press <Enter>. The message below will appear:
Type " Y" and press <Enter>. The modifications you have made will be
written into the CMOS memory, and the system will reboot. You will
once again see the initial diagnostics on the screen. If you wish to
make additional changes to the setup, press <Ctrl> <Alt> <Esc> simul-
taneously or <Del> after memory testing is done.

Exit Without Saving

When you do not want to save the changes you have made, highlight " Exit
Without Saving" and press <Enter>. The message below will appear:
Type " Y" and press <Enter>. The system will reboot and you will once
again see the initial diagnostics on the screen. If you wish to make any
changes to the setup, press <Ctrl> <Alt> <Esc> simultaneously or
<Del> after memory testing is done.

Desktop Management Interface (DMI)

The G586IPV system board comes with a DMI built into the BIOS.
DMI, along with the appropriately networked software, is designed to
make inventory, maintenance and troubleshooting of computer systems
easier. With DMI, a network administrator or MIS engineer can remotely
access some information about a particular computer system without
physically going to it. Quite often a service call may be unnecessary as
the problem can be solved remotely.
The DMI utility in the BIOS automatically records various information
about your system configuration. Information about the type and speed
of CPU, type and amount of memory for each memory slot, BIOS revi-
sion level, types of add-in PCI boards and components, certain revision
numbers of hardware installed, etc. are automatically detected and
52
Save to CMOS and Exit (Y/N)? N
Quit Without Saving (Y/N)? N