DFI G586IPV User Manual page 46

PCI Slot IDE 2nd Channel
This allows you to designate an IDE controller card inserted into one of
the PCI slots as your secondary IDE controller.
Enabl e d The IDE controller card is designated as the secondary IDE
controller.
No IDE controller card occupying any of the PCI slots.
Disabled
Onboard FDD Controller
Enabl e d Enables the onboard floppy disk controller.
Disables the onboard floppy disk controller.
Disabled
Onboard Serial Port 1 and Onboard Serial Port 2
Selects an address for the onboard serial port 1 and serial
Auto
3F8/IRQ4 port 2.
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disables the onboard serial port 1 and/or serial port 2.
Disabled
UART 2 Mode
The G586IPV system board supports IrDA function for wireless connec-
tivity between your computer and peripheral devices. To use the IrDA
function, follow the steps below.
1. Connect your IrDA cable to connector J11 of the G586IPV system
board. Refer to page 12 for the location of connector J11.
2. Set " UART 2 Mode" to the type of IrDA standard supported by your
IrDA peripheral/device.
You may not use IrDA (J11) and the COM 2 serial port (J5) at the same
time. If you are using the COM 2 serial port, set " UART 2 Mode" to
Standard.
46