Cache Memory; Installing The Cache Module - DFI G586IPV User Manual

1. Position the SIMM above the socket with the " notch" in the module
aligned with the " key" on the socket.
2. Seat the module at a 45° angle into the bank. Make sure it is com-
pletely seated. Tilt the module upright until it locks in place in the
socket.

Cache Memory

The G586IPV system board can support 256KB or 512KB pipeline
burst, direct map write-back cache SRAM. Your system board may
come with 256KB or 512KB cache mounted at locations U22 and U23
of the system board.
If your system board is mounted with 256KB cache, you may upgrade
your cache memory to 512KB by installing a 256KB cache module in
the 160-pin cache module slot (SSM1). Refer to page 12 for the loca-
tions of the SRAMs and cache module slot. If your system board is
mounted with 512KB cache, which is the maximum cache memory sup-
ported by the system board, the cache module slot will not be installed
on the system board.
Warning:
We highly recommend that you use the T2BSM32-256 or T3BSM256
cache module. If you are using a cache module other than the ones
recommended above, make sure your cache module meets the Intel
COAST 2.x or 3.x specification. Severe damage might occur on the
cache module or system board if you insert modules other than those
specified above.

Installing the Cache Module

Locate the 160-pin cache module slot on the system board (SSM1).
See page 12 for the location. Position the cache module above the slot.
Make sure pin 1 of the cache module is aligned with pin 1 of the slot.
Carefully slide the module into the slot. Press firmly on the top of it to
seat it properly.
16