DFI G586IPV User Manual page 43

Hide thumbs Also See for G586IPV:
Table of Contents

Advertisement

Resources Controlled By
The Award Plug and Play BIOS has the capacity to automatically con-
figure all of the boot and Plug and Play compatible devices. However,
this capability means absolutely nothing unless you are using a Plug
and Play operating system such as Windows
Auto
The system will automatically detect the settings for you. The
categories that follow will not be shown on the PNP/PCI Con-
figuration screen.
Manual
This allows you to set the IRQ/DMA (you have assigned your
add-in card) to Legacy ISA or PCI/ISA PnP. For non-PnP ISA
cards, select Legacy ISA. For PnP ISA or PCI cards, select
PCI/ISA PnP.
Reset Configuration Data
Enabled
The BIOS will reset the configuration data once automatically.
Disabled
The BIOS will not reset the configuration data.
PCI IRQ Actived By
This category is used to set the method by which the PCI bus recog-
nizes that an IRQ service is being requested by a device. Under all
circumstances, you should retain the default configuration unless a dif-
ferent setting is needed.
PCI IDE IRQ Map To
This category is used to configure your system to the type of IDE disk
controller in use.
ISA
Designates which ISA slot is installed with an IDE controller
card; that is, if you are using an IDE controller card.
PCI-Auto
The system will scan and determine the PCI slot that is in-
stalled with an IDE controller card.
®
95.
43

Advertisement

Table of Contents
loading

This manual is also suitable for:

G586ipv/e

Table of Contents