Table of Contents
Advertisement
PCI/ISA System Board
The screen displays the parameters detected and allows
you to accept or reject the parameters. Type "Y" and
press <Enter> to accept the parameters or press <Esc>
to abort. If you select "Y", the parameters of the hard
disk will be displayed in the Standard CMOS Setup.
Save & Exit Setup
When all the changes have been made, highlight "Save
& Exit Setup" and press <Enter>. The message below
will appear:
Type "Y" and press <Enter>. The following message
will appear:
Type "Y" and press <Enter>. The modifications you
have made will be written into the CMOS memory, and
the system will reboot. You will once again see the
initial diagnostics on the screen. If you wish to make
additional changes to the setup, press <Ctrl> <Alt>
<Esc> or <Del> simutaneously after memory testing is
done.
3-19 u Initial Setup Program
Save to CMOS and Exit (Y/N)? N
Reboot System (Y/N)? N
Advertisement
Table of Contents
