Supervisor Password - DFI G586IPV User Manual

Standard Uses the COM 2 serial port.
HPSIR HP mode IrDA.
ASKIR SHARP mode IrDA.
Onboard Parallel Port
378H/IRQ7 Selects the I/O address and IRQ for the onboard parallel port.
3BCH/IRQ7
278H/IRQ5
Disables the onboard parallel port.
Disabled
Parallel Port Mode
SPP Selects the parallel port mode according to the type of printer
EPP/SPP device connected to your onboard parallel port.
ECP
ECP/EPP
USB Controller
By default, the USB controller is Disabled. To use the USB controller,
set this option to Enabled. Refer to the Universal Serial Bus Connectors
section for instructions on connecting the USB ports.

Supervisor Password

If you want to protect your system and setup from unauthorized entry,
set a supervisor' s password with the " System" option selected in the
BIOS Features Setup.
If you want to protect access to setup only, but not your system, set a
supervisor' s password with the " Setup" option selected in the BIOS Fea-
tures Setup. You will not be prompted for a password when you cold
boot the system.
Use the arrow keys to highlight the " Supervisor Password" option and
press <Enter>. The message below will appear.
Enter Password:
47