Integrated Peripherals - DFI G586IPV User Manual

Integrated Peripherals

IDE HDD Block Mode
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Secondary Master PIO
IDE Secondary Slave PIO
On-Chip Primary PCI IDE
On-Chip Secondary PCI IDE
PCI Slot IDE 2nd Channel
Onboard FDD Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART 2 Mode
Onboard Parallel Port
Onboard Parallel Mode
IDE HDD Block Mode
The IDE HDD uses the block mode. The system BIOS will
Enabled
check the hard disk drive for the maximum block size the
system can transfer. The block size will depend on the type
of hard disk drive installed.
The IDE HDD uses the standard mode.
Disabled
IDE Primary Master/Slave PIO and IDE Secondary Master/Slave
PIO
Your system supports five modes, 0 (default) to 4, which primarily differ
in timing. When Auto is selected, the BIOS will select the best available
mode after checking your hard drive.
The BIOS will automatically set the system according to your
Auto
hard disk drive' s timing.
0-4 You can select a mode that matches your hard disk drive' s
timing. Caution: Do not use the wrong setting or you will
have drive errors.
On-Chip Primary PCI IDE and On-Chip Secondary PCI IDE
These categories allow you to enable or disable the primary and sec-
ondary IDE controller. The default is Enabled. Select Disabled if you
want to add a different hard drive controller.
ROM PCI/ISA BIOS
INTEGRATED PERIPHERALS
AWARD SOFTWARE, INC.
: Enabled USB Controller
: Auto
: Auto
: Auto
: Auto
: Enabled
: Enabled
: Disabled
: Enabled
: Auto
: Auto
: Standard
↑ ↓ → ←
ESC :Quit
: 378/IRQ7
F1 :Help PU/PD/+/-
: SPP
F5 :Old Values (Shift) F2
F6 :Load BIOS Defaults
F7 :Load Setup Defaults
: Disabled
:Select Item
:Modify
:Color
45