Front Bumper Assembly; Hood - Arctic Cat PROWLER HDX 2015 Service Manual

Front Bumper Assembly

REMOVING
Remove four cap screws and nuts. Account for four lock
washers and eight flat washers.
CLEANING AND INSPECTING
1. Clean all bumper components with hot, soapy water.
2. Inspect all welds for cracking or bending.
INSTALLING
Place the bumper assembly into position on the frame;
then secure with the four cap screws and nuts making
sure the flat washers and lock washers are properly posi-
tioned. Tighten securely.

Hood

REMOVING
1. Open the hood; then disconnect the four headlight
connectors and remove two nylon ties.
30
PR086
2. Loosen but do not remove the four cap screws and
flange nuts securing the hood hinge to the frame;
then lower the hood.
3. Finish removing the cap screws and flange nuts
(from step 2); then remove the hood assembly.
CLEANING AND INSPECTING
1. Clean all hood components with soap and water.
PR327A
2. Inspect the hood for cracks and/or loose fasteners.
3. Inspect for any missing decals.
INSTALLING
1. Place the hood into position on the vehicle; then
install the two outside cap screws and flange nuts.
Finger-tighten only at this time.
2. Open the hood; then install the remaining two cap
screws and flange nuts. Tighten all four securely.
PR328A
PR332A
PR332