Fenders; Floor - Arctic Cat PROWLER HDX 2015 Service Manual

3. Connect the four headlight connectors; then secure
the wires with two new nylon ties.

Fenders

REMOVING
Remove three torx-head screws securing each fender to
the frame. Account for a stiffener bracket on the front
fenders.
INSTALLING
Place the appropriate fender into position and secure with
existing hardware.

Floor

REMOVING
1. Remove the seat, seat back, and seat base.
2. Remove the self-tapping screws securing the side
foot restraints.
3. Remove the center floorboard.
4. While pulling forward on the upper-rear of the floor,
lift the rear part of the floor above the seat locating
PR332B
stud.
NOTE: To aid in removing, insert a small wood
block to hold in position.
PR311A
5. From the opposite side of the vehicle, repeat step 3;
then lift the rear of the floor up and lift the floor out
of the vehicle.
CLEANING AND INSPECTING
1. Clean the floor with soap and water.
2. Inspect the floor for cracks or holes.
INSTALLING
1. Place the front of the floor into position in the vehi-
cle first; then lower the rear and push past the seat
locating studs.
HDX132A
PR163
PR164
31