Hydraulic Brake System - Arctic Cat PROWLER HDX 2015 Service Manual

700
500
3. Loosen nuts (A) and (B) and adjust the cable housing
to align the shift cable end to the shift arm stud.
4. Install the E-clip; then tighten the nuts (A) and (B) to
8 ft-lb.
5. Check each gear shift position for proper gear selec-
tion and make sure the proper icon illuminates on the
LCD.

Hydraulic Brake System

NOTE: This ROV is equipped with hydraulic
brakes at all four wheels.
14
CHECKING/BLEEDING
The hydraulic brake system has been filled and bled at
the factory. To check and/or bleed a hydraulic brake sys-
tem, use the following procedure.
1. With the master cylinder in a level position, check
the fluid level in the reservoir. If the level in the res-
ervoir is not above the MIN, add DOT 4 brake fluid.
HDX251
2. Depress the brake pedal several times to check for a firm
brake. If the brake is not firm, the system must be bled.
To bleed the brake system, use the following procedure.
A. Remove the cover and fill the reservoir with DOT
4 Brake Fluid; then install and secure the cover.
HDX254
B. Slowly depress the brake pedal several times.
C. Remove the protective cap, install one end of a
clear hose onto the RIGHT REAR (700) or REAR
DRIVELINE (500) bleeder screw, and direct the
other end into a container; then while holding
slight pressure on the brake pedal, open the
bleeder screw and watch for air bubbles. Close the
bleeder screw before releasing the brake pedal.
Repeat this procedure until no air bubbles are
present. Then the rear left repeat B and C.
PR568A
PR095
REAR 500
HDX236A