Factory Resetting The Touch 8 Control Panel - Cisco TelePresence EX60 Administrator's Manual

Cisco TelePresence System EX Series
Contents
Factory resetting the Touch 8
control panel
you can reset the Touch 8 control panel to its default factory
settings using the new message indicator and the mute
button.
When factory resetting Touch 8 the logs are cleared, and the
configuration and pairing information are lost.
Touch 8 restarts after the reset and receives a new
configuration automatically from the video system.
It is not possible to undo a factory reset.
D14726.15 EX Series Administrator Guide TC7.2, AUGUST 2014.
Introduction Web interface
1. locate the
The New message indicator
the button with the exclamation mark on it.
2. Press and hold the
up (approximately 10 seconds).
3. Press the
The Touch controller automatically reverts to the default
factory settings and restarts.
System settings
New message indicator and Mute buttons.
is a bit hard to see, but it is
Mute button
New
message
indicator
New message indicator until it lights
Mute button twice.
128
Setting passwords
www.cisco.com — Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Appendices Appendices