Factory Resetting The Touch 8 User Interface - Cisco TelePresence SX20 Administrator's Manual

Cisco TelePresence SX20 Quick Set
Contents
Factory resetting the Touch 8 user
interface
You can reset the Touch 8 user interface to its default factory
settings using the New message indicator and the Mute
button.
When factory resetting Touch 8 the logs are cleared, and the
configuration and pairing information are lost.
Touch 8 restarts after the reset and must be paired to the
video system anew. When successfully paired it receives a
new configuration from the video system.
It is not possible to undo a factory reset.
D14908.10 SX20 Administrator Guide TC7.3, JULY 2015.
Introduction Web interface
1. Locate the
The New message indicator
the button with the exclamation mark on it.
2. Press and hold the
up (approximately 10 seconds).
3. Press the
The Touch controller automatically reverts to the default
factory settings and restarts.
System settings
New message indicator and Mute buttons.
is a bit hard to see, but it is
Mute button
New
message
indicator
New message indicator until it lights
Mute button twice.
139
Setting passwords
www.cisco.com — Copyright © 2012-2015 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Appendices Appendices