Cisco TelePresence EX60 Administrator's Manual page 62

Cisco TelePresence System EX Series
Contents
Cameras Camera [1] Gamma Mode
This setting enables gamma corrections. Gamma describes the nonlinear relationship between
image pixels and monitor brightness.
Requires user role: ADmIn
Value space: <Auto/manual>
Auto: Auto is the default and the recommended setting.
Manual: In manual mode the gamma value is changed with the gamma level setting, ref:
Cameras Camera [1..n] Gamma level.
Cameras Camera 1 Gamma Mode: Auto
Example:
Cameras Camera [1] Gamma Level
By setting the Gamma level you can select which gamma correction table to use. This setting
may be useful in difficult lighting conditions, where changes to the brightness setting does not
provide satisfactory results. requires the Gamma mode to be set to manual.
Requires user role: ADmIn
Value space: <0..7>
Range: Select a value from 0 to 7.
Cameras Camera 1 Gamma Level: 0
Example:
Cameras Camera [1] Whitebalance Mode
Set the camera white balance mode.
Requires user role: ADmIn
Value space: <Auto/manual>
Auto: The camera will continuously adjust the white balance depending on the camera view.
Manual: Enables manual control of the camera white balance. The white balance level is set
using the Cameras Camera Whitebalance level setting.
Cameras Camera 1 Whitebalance Mode: Auto
Example:
D14726.15 EX Series Administrator Guide TC7.2, AUGUST 2014.
Introduction Web interface System settings System settings
Cameras Camera [1] Whitebalance Level
Set the white balance level. requires the Camera Whitebalance mode to be set to manual.
Requires user role: ADmIn
Value space: <1..16>
Range: Select a value from 1 to 16.
Cameras Camera 1 Whitebalance Level: 1
Example:
www.cisco.com — Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.
62
Administrator Guide
Setting passwords Appendices