Table of Contents
Advertisement
Cisco TelePresence System Codec C90 and Profile 65" Dual using C90
Contents
Factory resetting the Touch 8
control panel
You can reset the Touch 8 control panel to its default factory
settings using the New message indicator and the Mute
button.
When factory resetting Touch 8 the logs are cleared, and the
configuration and pairing information are lost.
Touch 8 restarts after the reset and must receive a new
configuration from the video system.
•
If Touch 8 is directly connected to the video system it
receives the configuration automatically.
•
If it is connected via LAN it receives the new configuration
as soon as it is successfully paired to the video system.
It is not possible to undo a factory reset.
D14635.13 Profile C90 and Codec C90 Administrator Guide TC7.0, DECEMBER 2013.
Introduction
Web interface
1. Locate the
The
New message indicator
the button with the exclamation mark on it.
2. Press and hold the
up (approximately 10 seconds).
3. Press the
The Touch controller automatically reverts to the default
factory settings and restarts.
System settings
New message indicator
and
Mute
buttons.
is a bit hard to see, but it is
Mute button
New
message
indicator
New message indicator
until it lights
Mute
button twice.
135
Setting passwords
www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Appendices
Appendices
Advertisement
Table of Contents
