Network [1..1] Remoteaccess Allow - Cisco TelePresence EX60 Administrator's Manual

Cisco TelePresence System EX Series
Contents

Network [1..1] RemoteAccess Allow

Filter IP addresses for access to ssh/telnet/HTTP/HTTPS.
Requires user role: ADmIn
Value space: <S: 0, 255>
Format: String with a maximum of 255 characters, comma separated IP addresses or IP
range.
Network 1 RemoteAccess Allow: "192.168.1.231, 192.168.1.182"
Example:
Network [1..1] VLAN Voice Mode
Set the VlAn voice mode. The VlAn Voice mode will be set to Auto automatically if you have
Cisco UCm (Cisco Unified Communications manager) as provisioning infrastructure.
Requires user role: ADmIn
Value space: <Auto/manual/off>
Auto: The Cisco Discovery Protocol (CDP), if available, assigns an id to the voice VlAn. If
CDP is not available, VlAn is not enabled.
Manual: The VlAn ID is set manually using the network VlAn Voice VlanId setting. If CDP is
available, the manually set value will be overruled by the value assigned by CDP.
Off: VlAn is not enabled.
Network 1 VLAN Voice Mode: Auto
Example:
Network [1..1] VLAN Voice VlanId
Set the VlAn voice ID. This setting will only take effect if VlAn Voice mode is set to manual.
Requires user role: ADmIn
Value space: <1..4094>
Range: Select a value from 1 to 4094.
Network 1 VLAN Voice VlanId: 1
Example:
D14726.15 EX Series Administrator Guide TC7.2, AUGUST 2014.
Introduction Web interface System settings System settings
www.cisco.com — Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.
80
Administrator Guide
Setting passwords Appendices