Conference Settings; Conference [1..1] Activecontrol Mode; Conference [1..1] Autoanswer Mode; Conference [1..1] Autoanswer Mute - Cisco TelePresence EX60 Administrator's Manual

Cisco TelePresence System EX Series
Contents

Conference settings

Conference [1..1] ActiveControl Mode

Active control is a feature that allows conference participants to administer a conference on
Cisco TelePresence Server using the video system's interfaces (not available from the TrC5
remote control and on-screen display). Each user can see the participant list, change video
layout, disconnect participants, etc. from the interface. The active control feature is enabled
by default, provided that it is supported by the infrastructure (Cisco Unified Communications
manager (CUCm) version 9.1.2 or newer, Cisco TelePresence Video Communication Server
(VCS) version X8.1 or newer). Change this setting if you want to disable the active control
features.
Requires user role: ADmIn
Value space: <Auto/off>
Auto: Active control is enabled when supported by the infrastructure.
Off: Active control is disabled.
Conference ActiveControl Mode: Auto
Example:

Conference [1..1] CallProtocolIPStack

Select if the system should enable IPv4, IPv6, or dual IP stack on the call protocol (SIP, H323).
Requires user role: ADmIn
Value space: <Dual/IPv4/IPv6>
Dual: Enables both IPv4 and IPv6 for the call protocol.
IPv4: When set to IPv4, the call protocol will use IPv4.
IPv6: When set to IPv6, the call protocol will use IPv6.
Conference 1 CallProtocolIPStack: Dual
Example:

Conference [1..1] TelephonyPrefix

Enter the prefix to be used for telephony calls.
Requires user role: ADmIn
Value space: <S: 0, 80>
Format: String with a maximum of 80 characters.
Conference 1 TelephonyPrefix: "520"
Example:
D14726.15 EX Series Administrator Guide TC7.2, AUGUST 2014.
Introduction Web interface System settings System settings

Conference [1..1] AutoAnswer Mode

Set the auto answer mode. Use the Conference AutoAnswer Delay setting if you want the
system to wait a number of seconds before answering the call, and use the Conference
AutoAnswer mute setting if you want your microphone to be muted when the call is answered.
Requires user role: ADmIn
Value space: <off/on>
Off: you must answer incomming calls manually by tapping Answer on the Touch controller.
On: The system automatically answers incoming calls, except if you are already in a call. you
must always answer or decline incoming calls manually when you are already engaged in a
call.
Conference 1 AutoAnswer Mode: Off
Example:

Conference [1..1] AutoAnswer Mute

Determine if the microphone shall be muted when an incoming call is automatically answered.
requires that AutoAnswer mode is switched on.
Requires user role: ADmIn
Value space: <off/on>
Off: The incoming call will not be muted.
On: The incoming call will be muted when automatically answered.
Conference 1 AutoAnswer Mute: Off
Example:

Conference [1..1] AutoAnswer Delay

Define how long (in seconds) an incoming call has to wait before it is answered automatically by
the system. requires that AutoAnswer mode is switched on.
Requires user role: ADmIn
Value space: <0..50>
Range: Select a value from 0 to 50 seconds.
Conference 1 AutoAnswer Delay: 0
Example:
www.cisco.com — Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.
63
Administrator Guide
Setting passwords Appendices