Factory Resetting The Touch 8" Controller - Cisco Service Manual Service Manual

Cisco TelePresence SX20 Quick Set
Contents
Factory resetting the Touch 8"
controller
You must use the New message indicator and Mute buttons
to reset the Touch 8" controller to its default factory settings.
When factory resetting the Touch controller the logs will be
cleared, and the configuration and pairing information are
lost.
The Touch controller restarts after the reset and must be
paired to the video system anew. When successfully paired it
receives a new configuration from the video system.
It is not possible to undo a factory reset.
D14908.02 SX20 Administrator Guide TC6.0, JANUARY 2013.
Introduction Web interface
Touch
1. Locate the
The New message indicator
the button with the exclamation mark on it.
2. Press and hold the
up (approximately 10 seconds).
3. Press the
The Touch controller automatically reverts to the default
factory settings and restarts.
System settings
New message indicator and Mute buttons.
is a bit hard to see, but it is
Mute button
New
message
indicator
New message indicator until it lights
Mute button twice.
114
Setting passwords
www.cisco.com — Copyright © 2012-2013 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Appendices Appendices