Network Setting - Escene 102 Series User Manual

Disable sip account

Network Setting

If you want to ...
network setting --1) Select "Settings" > "Advanced settings"；
--2) Enter the password required（The default is empty) ；
--3) Select "Network", you can configure the following parameters:
Escene Communication
server,
-SIP2: the secondary SIP , When the primary server is
unavailable ,use the SIP server
-Refresh time: Registration refresh interval, the minimum value is
20 The default value is 3600.
-Con type: which protocol the phone used to send the
voip packets
-Amount of used lines: Maximum line are allowed to
used
--5) Set up the above parameters, select "Submit changes" to saves
settings, Complete the account creation.
--1) Select "Settings" > "Advanced setting"；
--2) Enter the password required（The default is empty) ；
--3) Select "SIP" > "Account sip"；
--4) Select "Enable account" > "Disable"；
--5) Select "Submit changes" to saves settings
-Type: static IP 、 DHCP 、PPOE
- DNS1: enter IP address of the primary DNS server
- DNS2: enter IP address of the secondary DNS server
-Web port: the default Web port is 80,if you change it(for example
change it to 88),you must use IP and Web port to login the web page (for
example http://192.168.0.200:88).It will take effect on next reboot.
-Telnet port: the default Telnet port is 23, if you change it (for
example change it to 2003), you must use IP and Telnet port to login the
102 Series IPPhone
Then...
www.escene.cn/en