Turning On Upnp In Windows 7 Example - ZyXEL Communications VMG1312-B Series User Manual

Use the following screen to configure the UPnP settings on your Device. Click Network Setting >
Home Networking > UPnP to display the screen shown next.
Figure 55 Network Setting > Home Networking > UPnP
The following table describes the labels in this screen.
Table 33 Network Setting > Home Networking > UPnP
LABEL
UPnP
UPnP NAT-T
#
Description
IP Address
External Port
Internal Port
Apply
Cancel

8.4.1 Turning On UPnP in Windows 7 Example

This section shows you how to use the UPnP feature in Windows 7. UPnP server is installed in
Windows 7. Activate UPnP on the Device.
Make sure the computer is connected to a LAN port of the Device. Turn on your computer and the
Device.
Click the start icon, Control Panel and then the Network and Sharing Center.
1
Chapter 8 Home Networking
DESCRIPTION
Select Enable to activate UPnP. Be aware that anyone could use a UPnP application to open
the web configurator's login screen without entering the Device's IP address (although you
must still enter the password to access the web configurator).
Select Enable to allow UPnP-enabled applications to automatically configure the Device so
that they can communicate through the Device by using NAT traversal. UPnP applications
automatically reserve a NAT forwarding port in order to communicate with another UPnP
enabled device; this eliminates the need to manually configure port forwarding for the UPnP
enabled application.
The table below displays the NAT port forwarding rules added automatically by UPnP NAT-T.
This is the index number of the UPnP NAT-T connection.
This is the description of the UPnP NAT-T connection.
This is the IP address of the other connected UPnP enabled device.
This is the external port number that identifies the service.
This is the internal port number that identifies the service.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
VMG1312-B Series User's Guide
135