Mac Authentication - ZyXEL Communications VMG1312-B Series User Manual

Table 21 Network Setting > Wireless > Guest / More AP > Edit (continued)
LABEL
Enhanced
Multicast
Forwarding
Guest WLAN
Access
Scenario
Maximum
Upstream
Bandwidth
Maximum
Downstream
Bandwidth
BSSID
E-mail notification when the wireless guest visit
Enable Email
Notification
Mail Server
Email Title
Send
Notification to
Email
Security Level
Security Mode
Apply
Cancel

7.4 MAC Authentication

This screen allows you to configure the Device to give exclusive access to specific devices (Allow)
or exclude specific devices from accessing the Device (Deny). Every Ethernet device has a unique
MAC (Media Access Control) address. The MAC address is assigned at the factory and consists of six
pairs of hexadecimal characters, for example, 00:A0:C5:00:00:02. You need to know the MAC
addresses of the devices to configure this screen.
Chapter 7 Wireless
DESCRIPTION
Select this check box to allow the Device to convert wireless multicast traffic into wireless
unicast traffic.
Select this to create Guest WLANs for home and external clients. Select the WLAN type in
the Access Scenario field.
If you select Home Guest, clients can connect to each other directly.
If you select External Guest, clients are blocked from connecting to each other directly.
Specify the maximum rate for upstream wireless traffic to the WAN from this WLAN in
kilobits per second (Kbps).
Specify the maximum rate for downstream wireless traffic to this WLAN from the WAN in
kilobits per second (Kbps).
This shows the MAC address of the wireless interface on the Device when wireless LAN is
enabled.
Select this to have the Device e-mail you a notification when a wireless client is connected
to the wireless network.
Select a mail server for the e-mail address specified below.
If you do not select a mail server, e-mail notifications cannot be sent via e-mail. You must
have configured a mail server already in the Maintenance > Email Notification screen.
Type a title that you want to be in the subject line of the e-mail notifications that the Device
sends.
Notifications are sent to the e-mail address specified in this field. If this field is left blank,
notifications cannot be sent via e-mail.
Select Basic (WEP, 802.1X) or More Secure (WPA(2)-PSK) to add security on this
wireless network. The wireless clients which want to associate to this network must have
same wireless security settings as the Device. After you select to use a security, additional
options appears in this screen.
Or you can select No Security to allow any client to associate this network without any data
encryption or authentication.
See Section 7.2.1 on page 98
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
VMG1312-B Series User's Guide
for more details about this field.
103