Adding A Qos Queue - ZyXEL Communications VMG1312-B Series User Manual

The following table describes the labels in this screen.
Table 46 Network Setting > QoS > Queue Setup
LABEL
Add new Queue
#
Status
Name
Interface
Priority
Weight
Buffer
Management
Rate Limit
Modify

10.4.1 Adding a QoS Queue

Click Add new Queue or the edit icon in the Queue Setup screen to configure a queue.
Figure 71 Queue Setup: Add
The following table describes the labels in this screen.
Table 47 Queue Setup: Add
LABEL
Active
Name
Interface
Chapter 10 Quality of Service (QoS)
DESCRIPTION
Click this button to create a new queue entry.
This is the index number of the entry.
This field displays whether the queue is active or not. A yellow bulb signifies that this queue
is active. A gray bulb signifies that this queue is not active.
This shows the descriptive name of this queue.
This shows the name of the Device's interface through which traffic in this queue passes.
This shows the priority of this queue.
This shows the weight of this queue.
This shows the queue management algorithm used for this queue.
Queue management algorithms determine how the Device should handle packets when it
receives too many (network congestion).
This shows the maximum transmission rate allowed for traffic on this queue.
Click the Edit icon to edit the queue.
Click the Delete icon to delete an existing queue. Note that subsequent rules move up by
one when you take this action.
DESCRIPTION
Select to enable or disable this queue.
Enter the descriptive name of this queue.
Select the interface to which this queue is applied.
This field is read-only if you are editing the queue.
VMG1312-B Series User's Guide
155