ZyXEL Communications VMG1312-B Series User Manual page 221

Figure 117 Access Control: Add/Edit
The following table describes the labels in this screen.
Table 88 Access Control: Add/Edit
LABEL DESCRIPTION
Filter Name Enter a descriptive name of up to 16 alphanumeric characters, not including spaces,
underscores, and dashes.
You must enter the filter name to add an ACL rule. This field is read-only if you are editing
the ACL rule.
Order Select the order of the ACL rule.
Select Source Select the source device to which the ACL rule applies. If you select Specific IP Address,
Device enter the source IP address in the field below.
Source IP Enter the source IP address.
Address
Select Select the destination device to which the ACL rule applies. If you select Specific IP
Destination Address, enter the destiniation IP address in the field below.
Device
Destination IP Enter the destination IP address.
Address
IP Type Select whether your IP type is IPv4 or IPv6.
Select Protocol Select the transport layer protocol that defines your customized port from the drop-down
list box. The specific protocol rule sets you add in the Security > Firewall > Service >
Add screen display in this list.
If you want to configure a customized protocol, select Specific Service.
Protocol This field is displayed only when you select Specific Protocol in Select Protocol.
Choose the IP port (TCP/UDP, TCP, UDP, ICMP, or ICMPv6) that defines your customized
port from the drop-down list box.
Custom Source This field is displayed only when you select Specific Protocol in Select Protocol.
Port
Enter a single port number or the range of port numbers of the source.
Chapter 18 Firewall
VMG1312-B Series User's Guide
221