Auto Firmware Upgrade Screen - ZyXEL Communications X6004 User Manual

Hide thumbs Also See for X6004:

Table of Contents

7.4 Auto Firmware Upgrade Screen

Use this screen to configure the information that IP phones connected to the

X6004 will use to upgrade their own firmware from an FTP server. To access this

screen, click Configuration > PBX > Server Configuration > Auto Provision

> Auto Firmware Upgrade.

Figure 74 Auto Provision > Auto Firmware Upgrade

Each field is described in the following table.

Table 39 Auto Provision > Auto Firmware Upgrade

X6004 User's Guide

Enter the filename of the firmware to be uploaded to the connected IP

Enter the FTP address that hosts the firmware.

Note: You must enter the full FTP path here or the upgrade will fail.

Enter the login username for the FTP server.

Note: This will be used by every phone connected to the X6004 so

be sure it does not have any restrictions or security issues,

such as one used by an administrator.

Enter the login password for the FTP server.

Note: This will be used by every phone connected to the X6004 so

be sure it does not have any restrictions or security issues,

such as one used by an administrator.

Chapter 7 Auto Provision