Table of Contents
Advertisement
Maintenance
To Clean the Machine
Wipe the machine with a damp cloth. If the dirt does not come off easily, try gently
wiping with a moistened soft cloth with a small amount of neutral detergent.
Scanner Setup
Normalization
Contact Image Sensors (CIS) can be sensitive to variations in room temperature. For
best results, the Scanner should be normalized on a regular basis. Normalization should
be performed whenever image uniformity is visibly changing across the CIS sensor
boundaries. This can happen when the Scanner is first installed or if the Scanner is
exposed to a temperature change. The Scanner should also be normalized after cleaning
it according to the scanner maintenance procedure.
The Normalization target that came with your system is used for this task. For detailed
normalization instructions, see System Administration, Scanner Setup in this guide.
Generally the System Administrator performs this task and may require a password to
access.
Stitch Alignment
Stitch maintenance is needed when line discontinuities are seen in the scan at or near
the four sensor boundaries. When the intersection of the sensors becomes visible on the
image, the printed image displays an upward or downward alignment in the lines, and
a Stitch Alignment is required. The Autostitch target that came with your system is used
for this task. See System Administration, for Stitch Alignment instructions.
7-12
®
Xerox
Wide Format 6604/6605 Solution
User Guide
Advertisement
Table of Contents
