Executing The Diagnostic Test - Toshiba T2100 Series Maintenance Manual

3.2

Executing the Diagnostic Test

Toshiba MS-DOS is required to run the T2100/T2105 Series computer Diagnostics Program.
To start the program, follow these steps:
1. Turn on the computer and allow the computer to boot. Insert the T2100/T2105
Series computer Diagnostics disk in the computer's internal floppy disk drive.
At the system prompt, change to drive A, type TEST2100, and press Enter .
2.
The following menu will appear:
TOSHIBA personal computer T2100 DIAGNOSTICS
version X.XX (c) copyright TOSHIBA Corp. 19XX
DIAGNOSTICS MENU :
1 - DIAGNOSTIC TEST
2 - HARD DISK FORMAT
3 -
4 - HEAD CLEANING
5 - LOG UTILITIES
6 - RUNNING TEST
7 - FDD UTILITIES
8 - SYSTEM CONFIGURATION
9 - EXIT TO MS-DOS
0 - SETUP
NOTE: To exit the T2100/T2105 Series computer DIAGNOSTICS MENU,
press the Esc key. If a test program is in progress, press Ctrl + Break to
exit the test program, or press Ctrl + C to stop it.
T2100 Series
↑ ↓ → ← : Select items
Enter : Specify
Esc : Exit
3-3