Toshiba T2100 Series Maintenance Manual page 159

4. Rotate the LCD module out of the cover from left to right.
5. Disconnect the display cable board from the LCD module.
6. Pull off the insulator attached by double-sided tape.
7. Disconnect the display cable from the display cable board to remove the board.
Installing the T2100CT LCD Module
To install the T2100CT's LCD module, follow the steps below and refer to Figure 4-31.
1. Connect the display cable board to the display cable.
2. Connect the display cable board to the LCD module.
3. Secure the insulator to the board by pressing gently to secure the tape.
4. Place the LCD module in the cover and route the cables so they will not be
pinched by the display panel or other components.
5. Secure the panel with four M2.5x6 screws. Be sure to secure the ground cable as
indicated in Figure 4-31.
6. Install the FL inverter board, display mask, optional memory module, optional
PCMCIA card and battery pack as described in Sections 4.17, 4.11, 4.4, 4.3 and
4.2.
T2100 Series
4-45