Display Mask - Toshiba T2100 Series Maintenance Manual

4.11 Display Mask

Removing the Display Mask
To remove the display mask, follow the steps below and refer to Figure 4-21.
1. Turn off the power to the computer, then disconnect the AC power cord and all
external cables connected to the computer.
2. Remove the battery pack, optional memory card, and optional PCMCIA card as
described in Sections 4.2, 4.3, and 4.4.
NOTE: It is not necessary to remove the display assembly.
3. Remove two rubber seals from the display hinges to expose two screws securing
the display mask.
4. Remove the two M2.5x6 screws that were covered by the rubber seals.
5. Carefully insert your fingers between the mask and the LCD panel and pry open
the latches. Start with the six latches across the top of the display mask. Be sure
not to misplace the LCD latch and the two LCD cushions located in the upper
corners of the mask.
6. Continue unlatching the mask along the sides (four latches on each side) and at
the bottom (three latches). There is also one latch at the larger display support.
4-28
Figure 4-21 Removing the display mask
T2100 Series