Toshiba T2100 Series Maintenance Manual page 160

4.19 T2100CT FL
Removing the FL
CAUTION: When you remove the FL, be careful not to let any dust or other foreign
matter contaminate the LCD panel. Any contamination can affect the performance of
the FL.
To remove the T2100CT's FL, follow the steps below and refer to Figures 4-32 through 4-34.
1. Turn off the power to the computer, then disconnect the AC power cord and all
external cables connected to the computer.
2. Remove the battery pack, optional memory module, optional PCMCIA card,
display mask, FL inverter board, and display module as described in Sections 4.2,
4.3, 4.4, 4.11, 4.17 and 4.18.
3 Place the LCD module face down and remove the four M2.1x6 screws (Figure 4-
32).
4. Unsnap the five latches securing the LCD frame to the LCD module (Figure 4-
32).
CAUTION: When you remove the LCD frame, eight hybrid ICs will be exposed at the
top/bottom of the LCD module. Use extreme care not to touch or jar these ICs.
Figure 4-32 Removing the T2100CT LCD module screws
4-46
T2100 Series