Toshiba T2100 Series Maintenance Manual page 162

Installing the FL
To install the T2100CT's FL, follow the steps below and refer to Figures 4-32 to 4-34.
1. Place the FL with the FL cable in the LCD module (Figure 4-34).
2. Lay the FL cover in place and snap the four latches to secure the cover (Figure 4-
33).
CAUTION: When you secure the four screws, be careful not to secure them
too tightly.
3. Lay the module in the frame and secure the five latches (Figure 4-32).
4. Secure the module to the frame with the four M2.1x6 screws (Figure 4-32).
5. Replace the LCD module, FL inverter board, display mask, optional memory card,
optional PCMCIA card and battery pack as described in Sections 4.18, 4.17, 4.11,
4.4, 4.3 and 4.2.
4-48
T2100 Series