Toshiba T2100 Series Maintenance Manual page 131

Installing the Hard Disk Drive
To install the hard disk drive, follow the steps below and refer to Figures 4-12 and 4-13.
1. Place the HDD in the HDD slot and slide the HDD to the right. Make sure the
HDD connects to the HDD connector on the system board (PJ502) (Figure 4-13).
2. Place the HDD bracket on the HDD.
3. Seat the battery holder assembly and secure the assembly and HDD bracket
with three M2.5x8 silver screws (Figure 4-13).
4. Seat the palm rest cover-support, and secure the HDD cover (Figure 4-13).
5. Connect the AccuPoint cable to PJ13 on the system board and place the palm rest
in the unit.
6. Turn the computer over and secure the bottom cover with the four pan-head
M3x6 screws (Figure 4-12).
7. Install the keyboard, optional memory module, optional PCMCIA card and battery
pack as described in Sections 4.5 back through 4.2.
T2100 Series
4-17