4.
Carefully lift up the keyboard to expose the keyboard connector (Figure 4-11).
5.
Disconnect the keyboard cable from pressure-plate connector (PJ14) on the
system board (Figure 4-11).
Installing the Keyboard
To install the keyboard, follow the steps below and refer to Figures 4-10 and 4-11.
1.
Connect the keyboard cable to pressure plate connector (PJ14) on the system
board (Figure 4-11).
2.
Replace the keyboard fitting the extensions on the back of the keyboard into
corresponding holes on the computer and lay the keyboard in place.
3.
Insert the keyboard brace between the AccuPoint cable and under side of the
keyboard (Figure 4-10).
4.
Secure the five latches on the keyboard base (Figure 4-10).
5.
Install the optional PCMCIA card, optional memory module and battery pack as
described in Sections 4.4, 4.3 and 4.2.
4-14
Figure 4-11 Removing the keyboard
T2100 Series