Installing the LCD Module
To install the T2100's LCD module, follow the steps below and refer to Figure 4-23.
1.
Connect the two display cables to CN1 and CN2 on the LCD module.
2.
Place the LCD module in the cover and route the cables so they will not be
pinched by the display panel or other components.
3.
Secure the LCD module with four M2.5x6 screws.
4.
Install the FL inverter board, display mask, optional PCMCIA card, optional
memory card and battery pack as described in Sections 4.12, 4.11, 4.4, 4.3 and
4.2.
T2100 Series
4-33